header_image



Takahashi PM-1 Mount

$3,375.00



The new Takahashi PM-1 was developed as a replacement for the P-2Z super eclipse mount. This highly portable mount offers the eclipse chaser and casual observer extreme flexibility and great convenience. The built in 9x polar alignment allows the PM-1 to be accurately polar aligned in either hemisphere until the year

 

2030. A standard illuminator is proved to make the polar alignment procedure easier.

 

 

 

The entire mount and small wooden tripod can be packed in small cases and transported to remote sites or an airline carry on.

 

The PM-1 features a clutch system that allows the mount to be operated in three modes:

 

 

 

1. Disengaged: for slow motion movement and no movement by the motor drive. The clutch is loosened and the RA shaft can slip.

 

2. Partial clutching: the clutch knob is partially engaged to allow movement by motor drive and by slow motion control. The RA shaft can slip for slow motion movement.

 

3. Total clutching: the clutch knob is tightened as much ad possible for motor drive operation only.

The altitude scale and bubble level are included to allow daytime polar alignment of the PM-1 using the meridian line for a solar eclipse. The meridian line can be determined with a compass. The altitude scale can be used to the polar axis on the north celestial pole. Altitude and azimuth slow motion controls are provided to allow for fine and precise polar alignment setting.

 

The motor drive operates on 6v DC power located inside of the hand controller for the mount. This eliminates a separate battery pack. This controller allows the mount to track at five different rates: sidereal, solar, 0.7x, 0.5x and 0.3x sidereal rate in either

 

Hemisphere. The solar and sidereal rates provide a stead platform for solar eclipse imaging as well as planetary, lunar and deep space observing. Drive correction is made with the buttons on the hand control.

 

Installing the Teegul camera platform on top of the Dec assembly turns the PM-1 into a multi-camera platform. The mount has two  x 20 studs on the side of the Dec. assembly to accept ball joint platforms for DSLRs and lenses. A fourth camera can also be added to the counter weight shaft. This configuration is good for meteor imaging as well imaging large areas of the night sky.

 

 

 

 

 

 

 

 

 

 

 


 

Add to Cart:

Add to Cart:

  • Model: TPM0001
  • Shipping Weight: 15lbs
  • Manufactured by: Takahashi

This product was added to our catalog on Thursday 05 April, 2012.